We make a lot of stencils here at Laser Engraving Pros. We make little ones, big ones, plastic ones- you name it! laser cutting is ideal if you need to label or mark various surfaces many, many times. We can make stencils up to 52″ wide X 60″ Tall. Talk about a giant stencil right? Personally I’ve never made a stencil bigger than 3×4, but if you have a need that is bigger – bring it on! Banksy, feel free to stop by if you’re ever in the area. This super awesome crab stencil was laser-cut out of mylar. It’s 3×4 feet (at the time that was my maximum, so I needed two pieces) But now I can make stencils that are 52″ x 52″ in one full piece. laser cutting – We generally make our stencils out of mylar as it’s water proof.
The best way to lay down paint over a stencil is to use very thick paint and a roller. The thicker the paint the less likely it is to run under the stencil after you run the roller over it. We offer laser cutting in almost any size and on several different substrates. We can laser-cut letters up to 18″ tall x 32″ wide and can handle very detailed images when you need stencils.Mylar and Polycarbonate stencils are by-far the best materials to use when laser cutting are required. They are water proof, hard to tear and can be used over and over again. Basic stencils like this oil-board pictured above will break down over time and deteriorate. laser cutting – laser cutting are ideal if you need to label or mark various surfaces many many times. We offer laser cutting in almost any size and on several different substrates.